206031 Front Disc Brake 206031 REMOVAL AND INSTALLATION Brake Caliper 40L SOHC and 46L 3V Material Item Specification High Performance DOT 3 Motor Vehicle Brake Fluid PM1 or PM1C US CPM1 or CPM1C Canada ESAM6C25A or WSSM6C62A 1 With the vehicle in NEUTRAL position it on a hoist For additional information refer to Section 10002 2 Remove the brake caliper flow bolt and discard the 2 copper washers 3 CAUTION Do not use the caliper sight hole to retract pistons as this can damage the pistons and boots Remove and discard the 2 brake caliper guide pin bolts and remove the brake caliper Removal WARNING Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative Failure to follow these instructions may result in personal injury WARNING Carefully read cautionary information on product label For EMERGENCY MEDICAL INFORMATION seek medical advice In the USA or Canada on FordMotorcraft products call 18009593673 For additional information consult the product Material Safety Data Sheet MSDS if available Failure to follow these instructions may result in personal injury CAUTION Brake fluid is harmful to painted and plastic surfaces If brake fluid is spilled onto a painted or plastic surface immediately wash it with water Copyright 2006 Ford Motor Company Last updated 6192006 4 Inspect the brake caliper If leaks or damaged boots are found install a new brake caliper Installation 1 Position the brake caliper and install 2 new guide pin bolts 2 Tighten to 34 Nm 25 lbft Using 2 new copper washers position the brake flexible hose on the brake caliper and install the brake caliper flow bolt Tighten to 40 Nm 30 lbft 3 Bleed the brakes For additional information refer to Section 20600 4 Test the brakes for normal operation 2007 Mustang Mustang GT 82006